High sensitivity scan for over 250 compounds
Detects MVOCs without visual contact or microbial sampling
Scan of compounds off-gassing from solids, semi-solids, water, or liquids
FT-IR Spectrometry can be mobilized in the field to collect and analyze data at or close to the source
FT-IR Spectrometry used in the field to capture real-time data
Analysis of airborne particulates
Custom method development/adaptation
Q.

What is TDT Air Scan®?
A.
TDT Air Scan® is multi-matrix sorption tube that is designed to trap a wide range of compounds from the air. These include both polar and non-polar compounds. After sampling, the sorption tube is sent to PATI for the qualitative and quantitative identification of over 350 compounds.
Q.

What kinds of compounds are detrmined by TDT Air Scan®?
A.
The 350 plus compounds determined by TDT Air Scan® include aldehydes, esters, halogenated, alcohols, hydrocarbons, nitro-nitriles, ketones, aromatics, and sulfides. A specific list of compounds can be found in Tech Bulletin 503.
Q.

Is there a difference between a Library Search and TDT Air Scan®?
A.
Yes there is! Technical Bulletin 528 explains the differences.
Q.

How long do I need to wait after the last of the painting, flooring, etc., in order to give accurate results on what the air quality will be longer term?
A.
Before sampling, you should wait an ablsolute minimum of 14 days after renovation; however, 30 days would be better. Waiting more than 30 days provides no additional benefit. During this time, air changes/hr should be increased. If you don't have a way to do this using your HVAC system, opening a few windows a crack will also work. Then, close the windows, wait 24-48 hours and sample. Remember, don't fry anything during the 24 hours before sampling or cook anything during the 6 hours before sampling. Be sure all interior doors are open during sampling.
Q.

What is sub-slab sampling?
A.
Sub-slab sampling is done to look for and identify chemicals that are diffusing into the occupied space from under a concrete floor. The chemicals were spilled before the floor was poured, were spilled after the floor was poured and seeped down through cracks, or migrated under the slab through the groundwater. TDT Air Scan® is ideal for sub-slab sampling because there is no need to destroy the floor to take a sample of the soil/sand/gravel underneath. All that is needed is a 3/8 inch diameter hole through the concrete at the desired location. Place a sample tube 1/2 inch from the bottom of the hole and pull an air sample using a personal monitoring pump. TDT air Scan® surveys for over 300 compounds using one sample tube. For more information contact PATI.
Copyright © 2003-2006 Prism Analytical Technologies, Inc. All rights reserved.